|
Post by gdb133 on Dec 25, 2021 14:33:49 GMT -8
I've just received an X-sight LTV 3-9x scope for Christmas and I was only able to turn it on once. It worked for maybe 30 seconds and now I can't get it to come back on so I put it on the charger to see if that made a difference. It's been charging for about 2.5 hours now and I've still not been able to get it to work. The scope won't make the clicking noise on startup, doesn't even attempt to boot up, and the computer will not recognize the scope for a firmware update. I've exhausted all the options I've come across in the forums and I'm getting ready to just send it back after just 30 seconds of operating time. If anyone has any suggestions, it would be highly appreciated as I was quite excited to use the scope tonight.
Thanks
|
|
kellykrk
Member
Posts: 22
ATN Products Owned: Night Vision Optics, Thermal Optics
|
Post by kellykrk on Dec 25, 2021 14:50:00 GMT -8
Try holding power button down for 30 seconds this will force it off i believe if it is stuck in an on position then do an update maybe. after you have held it down for 30 seconds do not try to turn it on . just follow update instructions.
|
|
kellykrk
Member
Posts: 22
ATN Products Owned: Night Vision Optics, Thermal Optics
|
Post by kellykrk on Dec 25, 2021 14:54:22 GMT -8
Also make sure you are using a sd card that is supported.
|
|
|
Post by gdb133 on Dec 25, 2021 20:00:04 GMT -8
Also make sure you are using a sd card that is supported. I appreciate the tip, however, I think I'm just going to send it back. I didn't expect to be troubleshooting a new scope.
|
|