|
Post by joetillman on Sept 9, 2017 9:11:12 GMT -8
Just got a XD sight 5 x 20. It was working ok, I hooked it up to the ATN Obsidian app, after some work at doing it...well it finally hooked up and now the buttons on the sight do not work. It will power on and now just sits on the first screen where it powers on to. It will not do anything once it turns on and the power button doesn't work once it is on, I have to remove the batteries to even shut it off. The indicators are all at zero and the compass stays on N no matter where I point the sight or roll it either. Any suggestions on what to do, I'm about ready to return this thing!
|
|
|
Post by joetillman on Sept 9, 2017 15:28:14 GMT -8
Any help would be appreciated.....after 6 hours of sitting with no batteries, still the same. Really frustrating spending this kind of money for a brick!
|
|
Misfire
Member
Posts: 4
ATN Products Owned: Smart HD Optics
|
Post by Misfire on Mar 6, 2019 18:27:41 GMT -8
For powering it off, have you tried holding down the power button for 20-22 seconds instead of removing the batteries? It’s like a hard re-boot and mine has always operated normally afterwards. If you get the display alive again and the compass is still locked up, try rotating the sight in all three axis: end over end, spin it around and roll it a few turns each direction. As far as the problem of locking up with the app, I’m having the same problem.
|
|