|
Post by gallor1 on Mar 19, 2017 12:06:16 GMT -8
Hello All, I recently purchased An X Sight ii 5-20x and I must say so far I like it. Here is my issue: I am not on paper at 100 or 50 yards so there is no way for me to use the one shot zero feature, I brought my target in to 10 yards and low and behold i was low to the left, I used the zero feature at that point and it worked perfect, Now I send my target out to 50 and my hole is no where in sight. I am new to this sight and I am looking for advice.
Thanks in advance
|
|
jdb
Contributor
Posts: 41
|
Post by jdb on Mar 19, 2017 14:15:42 GMT -8
There is a thread in the X-Sight II area that gives a twelve(12) step method for zeroing a scope. Look through and find that...it's good. Also make sure your zero range is set to the distance you originally zeroed, the distance to target is appropriate, your sight height above bore is correct and you have entered the proper device type in the settings
|
|
oldspook
Super Contributor
Posts: 404
ATN Products Owned: Smart HD Optics
|
Post by oldspook on Mar 19, 2017 14:50:27 GMT -8
Hello All, I recently purchased An X Sight ii 5-20x and I must say so far I like it. Here is my issue: I am not on paper at 100 or 50 yards so there is no way for me to use the one shot zero feature, I brought my target in to 10 yards and low and behold i was low to the left, I used the zero feature at that point and it worked perfect, Now I send my target out to 50 and my hole is no where in sight. I am new to this sight and I am looking for advice. Thanks in advance Then send your target out to 25. If it is low and left at 10 it will be about five times as low and five times as left at 50. So if it was 6 inchs low and three inches left at 10 it's going to be 30 inches low and 15 inches left at 50.
|
|
|
Post by gallor1 on Mar 19, 2017 16:43:33 GMT -8
Thank you will do.
|
|
odin
Expert Contributor
Laxing out in the land of Rugby, Hunting and Fishing.
Posts: 726
ATN Products Owned: Smart HD Optics
|
Post by odin on Mar 20, 2017 13:51:04 GMT -8
|
|
testament
Frequent Contributor
Posts: 54
ATN Products Owned: Smart HD Optics
|
Post by testament on Mar 23, 2017 15:10:23 GMT -8
Also make sure your sight height is accurate and updated in the scope, SSS is not on while zeroing. Once your zeroed u can have SSS on but make sure all that data is entered correctly and accurate and don't forget to change range manually for range of target you are shooting at if SSS is on.
|
|