|
Post by bocephuss on Feb 2, 2017 21:24:36 GMT -8
Wondering if one of you has experienced these flashing bars going up and down accross the screen of your thermals like I'm seeing in mine. Everytime I NUC it they will change positions or flash around. Its almost like watching the start of an old reel movie where you can watch the lines go up and down.
It appears my thermal is up to date on the firmware as well. Although on my scope it ends in ".en" where I don't see that on the firmware listed here. Is that still the correct version?
Thanks.
|
|
Dr. Detector
Top Contributor
Posts: 136
ATN Products Owned: Smart HD Optics
|
Post by Dr. Detector on Feb 6, 2017 11:15:52 GMT -8
System Reboot to factory settings until it fixes it ;o)
"Doc"
|
|
|
Post by richard on Mar 31, 2017 9:44:08 GMT -8
You say to reboot to factory settings "until" it fixes it. Does that mean that simply rebooting to factory settings doesn't reboot to factory settings? We need to reboot more than once? After we reboot to factory settings do we reinstall newest firmware?
|
|
Dr. Detector
Top Contributor
Posts: 136
ATN Products Owned: Smart HD Optics
|
Post by Dr. Detector on Mar 31, 2017 12:12:08 GMT -8
In previous firmware versions I did find that rebooting multiple times did change image quality. Since the new version a handful of weeks I have not had to do so and my other bugs were fixed as well.
|
|
|
Post by mrbear on May 10, 2017 12:14:44 GMT -8
Try turning off the WiFi to see if that makes the issue go away... I think ATN may have an issue with not shielding the WiFi signal from sensitive parts
|
|