ret
Member
Posts: 2
|
binox
Jul 28, 2016 14:09:39 GMT -8
Post by ret on Jul 28, 2016 14:09:39 GMT -8
Purchased a pair of these but cant get firmware to load off micro sd card. Still only able to use version 1.8. Any ideas on how to correct this problem? Thanks in advance.
|
|
ret
Member
Posts: 2
|
Post by ret on Jul 28, 2016 15:09:06 GMT -8
nevermind figured it out
|
|
|
binox
Sept 7, 2016 8:07:15 GMT -8
Post by themadmax on Sept 7, 2016 8:07:15 GMT -8
What did you do? Having the same issue. No answer from support yet.
|
|
|
binox
Nov 26, 2016 2:14:14 GMT -8
Post by tolley on Nov 26, 2016 2:14:14 GMT -8
What did you do? Having the same issue. No answer from support yet. they do seem a bit slow to answer .
|
|
|
binox
Jun 7, 2018 11:30:43 GMT -8
Post by fredd72 on Jun 7, 2018 11:30:43 GMT -8
What did you do? Having the same issue.
|
|
retired
Top Contributor
Posts: 189
ATN Products Owned: Night Vision Optics
|
Post by retired on Jun 15, 2018 22:38:53 GMT -8
For those new owners have trouble updating the firmware, here are a couple of suggestions. Use a fast SD card, I used a SanDisk Ultra Plus 64GB micro SD card. Format the micro SD card on your computer and download the firmware update onto the card. Do not try to open the update, it will corrupt the file. Make sure your Binox is turned off, remove the micro SD from the computer and load it into the Binox. Turn the Binox on and follow the instructions. After your Binox is updated remove the card and perform a factory reset. Place the micro SD in your computer an format it to remove the update file and place it back in the Binox to take photos and videos.
I recently purchased a 4K Pro scope and it took several tries to get it to load properly but I followed the above list and it did load.
Retired
|
|