Ran 100 rounds though using the process below and cant get on paper, much less zero’d beyond 25 feet
Zero Process:
- Do a factory reset to clean any corrupted data.
- Select your scope or device type in Settings.
- Select the Profile you wish to zero. You can add new profiles in the scope menu and edit them using your smart aleck phone.
- Zero "Range" of 50 yds. works great on most calibers. And it is easy to see!
- Make sure all data lines are updated. The factory provides default data that you must update: Bullet weight., muzzle velocity, scope height, etc..
- Don't forget to measure and enter your scope height! (Center of bore to center of front lens).
- Bore Sight, if possible. Some rail adapters have adjusters for elevation.
- Select "Zero reticle."
- Start at base magnification (3X or 5X)
- Shoot a round. Move the colored reticle to the bullet hole. Don't "zoom" to look. The white reticle (doesn't move with button clicks) must be held where you aimed originally.
- Click "Enter." Select "Save and Exit."
To fine tune, Select "Zero Reticle." Zoom to your highest magnification
Repeat process.
QD mount - Used laser sight to zero in. Zero’d at 20’. Moved back to 100yds. Laser was at least 2 feet high, off the target. Zero’d back to center of bulls eye. Shot didn’t even hit board or paper. Was way off target. Put laser back in and laser was on target.
Changed to fixed mount
Fixed mount - above process all over again. Shot never got on target or board (board is about 16” around target).