|
Post by jrswampy on Nov 9, 2021 19:19:50 GMT -8
I'm using a Vortex rangefinder. It has 2 modes, Line Of Sight (LOS) and Horizontal Component Distance (HCD). Basically, LOS is just as it sounds, it's a measurement of a straight line to the target. If there is an incline or decline, this distance will be greater than HCD. HCD uses the LOS reading and the built in incline meter to determine the horizontal distance.
Which setting should I use to input in to my X-Sight 4K? I'm thinking HCD...
|
|
tciii
Contributor
Posts: 46
|
Post by tciii on Nov 9, 2021 22:40:33 GMT -8
LOS....the scope computes the incline or decline you are shooting at.
|
|
|
Post by jrswampy on Nov 10, 2021 7:03:07 GMT -8
LOS....the scope computes the incline or decline you are shooting at. Thanks. That's what I was thinking at 1st but the Vortex instructions say to use HCD to input when using a ballistics calculator.
|
|