|
Post by tangenarms on Sept 9, 2019 16:50:34 GMT -8
Hello Everyone,
I attempted to use the USB method of updating the FW for the ThOR4 and it did basically nothing and now I cannot get the unit to power up at all. I downloaded the USB file. ran the setup and the directions come up. Followed the directions step by step, powered off the unit, attached the USB, selected my product, simultaneously pressed the down arrow and power buttons.....at this point the update button on the screen should turn blue but it did not. Nothing actually happened. I tried to power up the unit and nothing. usb plugged in or not, I cannot get the unit to do anything at all. Any advise??
|
|
|
Post by tangenarms on Sept 9, 2019 17:18:18 GMT -8
ok, crisis overted. I missed the tip about holding the power button for 15 seconds to reboot. did that and all is back to normal. still need to figure out the FW install .
|
|
|
Post by koke915 on Sept 11, 2019 3:32:14 GMT -8
Hi guys, good day. I have an ATN Thor 4. I installed the latest firmware version available on the ATN website, after that it started shutting down alone, I tried to reinstall other firmware without results. Someone else has happened, how did they solve it?
|
|
|
Post by lespaul21 on Feb 28, 2020 20:25:00 GMT -8
Hello Everyone, I attempted to use the USB method of updating the FW for the ThOR4 and it did basically nothing and now I cannot get the unit to power up at all. I downloaded the USB file. ran the setup and the directions come up. Followed the directions step by step, powered off the unit, attached the USB, selected my product, simultaneously pressed the down arrow and power buttons.....at this point the update button on the screen should turn blue but it did not. Nothing actually happened. I tried to power up the unit and nothing. usb plugged in or not, I cannot get the unit to do anything at all. Any advise?? These scopes are garbage. They lock up constantly. They are completely unreliable.
|
|
|
Post by diodebill on Jun 12, 2020 5:10:07 GMT -8
Like-wise had same issue. I did the power and down button to reset. I had the firmware loaded on card in unit. I plugged into usb and into laptop. I used the downloaded program to correct issues, despite not powering on using the power button. I started the program, used the password and then went to the file method of updating the firmware, it worked. Firmware update was done and the scope turned on. I had halos on left side. I had originally returned to amazon. I knew the serial number, returned to Amazon where I had purchased. They repackaged and sent the same unit back to me. I have now returned to Amazon for refund. Will order from ATN once I know there are no more issues with the THor 4 640 1-10X
|
|