|
Post by ticktock on Oct 24, 2018 6:41:29 GMT -8
I have a couple of requests for ATN to consider for future firmware updates. The first two should be relatively easy.
1) Add ability to enter a horizontal offset to the scope mount. You already have an entry for the scope height above the barrel, it would be great if I could also enter a +/- value for horizontal offset to enable for more mounting options. 2) Keep image dimmed at lowest setting until the bootup procedure knows what the user setting is. Right now, the screen is very bright until the end of the boot. I made the mistake of looking into the scope while it was booting one night and it took 20 minutes for my eyesight to recover. 3) Reduce boot time! This is probably a much harder problem to solve but, perhaps, the most important. Most of the features can come online later but the scope needs to turn on (at the set brightness) with a reticle (at the previously set distance) in less than 2 seconds.
|
|
|
Post by turkeytracks on Nov 30, 2018 6:28:04 GMT -8
How about a green mode in night vision
|
|
|
Post by mrnewbie on Dec 16, 2018 22:04:05 GMT -8
RAV sensitivity adjustment … low/high so .22 and .17hmr's will trigger it
|
|
nighthunter
Frequent Contributor
Posts: 66
ATN Products Owned: Smart HD Optics, Night Vision Optics, Thermal Optics
|
Post by nighthunter on Dec 17, 2018 10:20:50 GMT -8
It would be great if the distance only showed in the view, photos and videos when the Balistic Calculator is active. This would make more relevant information in the view, photos and videos. Currently the distance indicator may or may not be correct. Those of us who share photos and videos currently have to explain that the distance is not correct if we are not using the Balistic Calculator.
|
|
|
Post by number40fan on Dec 23, 2018 16:26:42 GMT -8
How about a completely dumbed down version?
No:
ABL Wifi BT Recording Pictures
Just a cross hair that is adjustable.
|
|