|
Post by 98harleyman on Aug 22, 2020 10:13:22 GMT -8
Ok I will go back and look at it thanks for the information. That will be great and I agree with the balance part and relieving stress on the scope that would be awesome.
Thanks!
|
|
tciii
Contributor
Posts: 46
|
Post by tciii on Aug 22, 2020 16:06:39 GMT -8
They make some aftermarket 3d printed cone shaped spacers to go on the back side of the front bell to aid in support. I have them and they work great. Search Apex 3D printing and design.I wrapped 2 layers of thin electrical tape on the bell and the cone spacers to allow the clamp to hold better and protect the scope bell finish.
PS...you will have to pry open the mount a little bit with your fingers to get it to slide to the back of the bell from the front.
|
|
|
Post by skcs on Jun 6, 2022 20:25:23 GMT -8
I mounted my ABL behind the focus ring. Works great with the provided spacers.im trying to figure out how to upload a photo
|
|